Narrative:

I signed-off a 100-hour inspection on a sportstar evektor aircraft. Part of the inspection was inspecting the brakes. The brakes on the left side were close to the wear limit so I removed the wheel to remove the brake linings so I could more easily measure the lining. The brakes were found to be in an airworthy condition so they were re-installed on the aircraft; then the wheel was re-installed. When replacing the cotter pin; the first cotter pin I attempted to use was too short so I used another. The service manual called for a 4X.04 [cotter pin]; the one I used was 4X.36; well at least I thought I used it. At first we thought that it had come out; but when myself and an FAA representative tried it; it did not go through the axle; so I assumed I just forgot to use a cotter pin. During the time that I put the one that was too short back and got the other one; I had a phone call and I felt rushed because the aircraft was a flight school airplane and needed to be put back on the schedule for the weekend and I assume; from all the stress; it just slipped my mind. The pilot and I took the aircraft for a test flight; which was also part of the check list and everything was fine. Then; two days later; the aircraft was doing touch and goes and on the last take-off the pilot said that he felt a vibration; then when landed found the tire had fallen off. The wheel and nut were both found; the wheel was located in the grass just off of the runway and the nut was found on the runway. The aircraft sustained minor damage and nobody was hurt. I have never had anything like this happen before and have learned a lesson from this and that is to slow down and double check all my work before I let the aircraft leave the shop. I feel horrible about this and it will never happen again.

Google
 

Original NASA ASRS Text

Title: An FBO Mechanic reports a left Main Landing Gear (MLG) tire and wheel assembly had separated from a SportStar Evektor aircraft on takeoff; two days after he had completed a 100-hour Inspection.

Narrative: I signed-off a 100-Hour Inspection on a SportStar Evektor aircraft. Part of the Inspection was inspecting the brakes. The brakes on the left side were close to the wear limit so I removed the wheel to remove the brake linings so I could more easily measure the lining. The brakes were found to be in an airworthy condition so they were re-installed on the aircraft; then the wheel was re-installed. When replacing the cotter pin; the first cotter pin I attempted to use was too short so I used another. The Service Manual called for a 4X.04 [cotter pin]; the one I used was 4X.36; well at least I thought I used it. At first we thought that it had come out; but when myself and an FAA representative tried it; it did not go through the axle; so I assumed I just forgot to use a cotter pin. During the time that I put the one that was too short back and got the other one; I had a phone call and I felt rushed because the aircraft was a flight school airplane and needed to be put back on the schedule for the weekend and I assume; from all the stress; it just slipped my mind. The pilot and I took the aircraft for a Test Flight; which was also part of the Check List and everything was fine. Then; two days later; the aircraft was doing Touch and Goes and on the last take-off the pilot said that he felt a vibration; then when landed found the tire had fallen off. The wheel and nut were both found; the wheel was located in the grass just off of the runway and the nut was found on the runway. The aircraft sustained minor damage and nobody was hurt. I have NEVER had anything like this happen before and have learned a lesson from this and that is to SLOW down and double check ALL my work before I let the aircraft leave the Shop. I feel horrible about this and it will NEVER happen again.

Data retrieved from NASA's ASRS site as of July 2013 and automatically converted to unabbreviated mixed upper/lowercase text. This report is for informational purposes with no guarantee of accuracy. See NASA's ASRS site for official report.